Welding Tips And Tricks

1/4" Thick Lap Joint PrimeWeld MTS200 This first video is a super quick one showing settings that are a bit lower than what the MIG chart settings recommend. The recommended wire speed for 1/4" was 472 ipm using .035" wire...

Preliminary welding procedure Is a full penetration bead on plate  the same as a weld joint?  Well it depends. If it's a butt joint with no gap at all and a good fit, and the edges have been cleaned properly, then...

11ga Carbon Steel Tee Joint Made Simple I used the PrimeWeld TIG225 at 120 amps full pedal. 3/32" 2% lanthanated tungsten   ER70S-2 AND -6 1/16" diameter TIG rod Jazzy 10 ceramic cup at 25 cfh argon

What is the best filler rod for TIG welding carbon steel? Is it good old ER70s-2? or ER70s-6 with higher silicon content? The differences between ER70S-2 and ER70S-6 are pretty subtle for fillet welds on clean metal. And even on light mill...

Lucky 7 Clear Cup Combo  Kit on Aluminum For quality Welding Gear https://weldmongerstore.com/ There are lots of opinions on what is the best tig cup for aluminum. Some prefer a #5 standard collet body cup while others prefer a #6...