Material type and thickness was 1018 steel 11ga .120" (3mm)
18.1 volts 149ipm using .035" ER70S6 wire, C25 gas at 25cfh
This is a 2f position horizontal corner joint.
It is only slightly different than a 1F flat position and certainly no more difficult.
In fact, I find it a bit easier just because it's more comfortable for me.
I am willing to bet that some comments on youtube will tell me things like
"you should always push with mig".
I think saying "Always" is a pretty strong stance to take when it comes to welding.
I like to test welds by the cross section method to see the depth of penetration.
I have probably tested more than 100 mig welds using both pulling and pushing angles and am confident in saying both work fine if you avoid steep angles.
