1/4" Thick Lap Joint PrimeWeld MTS200

This first video is a super quick one showing settings that are a bit lower than what the MIG chart settings recommend. The recommended wire speed for 1/4" was 472 ipm using .035" wire and that seemed a bit high with a lot of spatter so I trimmed back the wire speed and tested the joint after welding.

20 volts

310 ipm .035" ER70S-6 C25 gas

INDUCTANCE set to max

Did you Know that the PrimeWeld MTS200 Also does Lift Arc TIG?

Setting up the MTS200 for Lift Arc TIG is pretty easy.

The CK Worldwide Air cooled torch with valve connects directly to the flowmeter and you simply use the torch valve to turn argon on and off.